KKOB INSERT
Found to use uses 15C-TS7 knob cap
CROSS COMPATIBILITY TO OLDER REELS NOTES READ CAREFULLY!
Replaces original 15-950M (knob redesigned by Penn)
Fits these Main Gears: 8P-7500, 8N-7500, 8N-750 (newer)
IMPORTANT! For Older 850SS and 750SS reels subbing to this part.
THE DIFFERENCE?? The original gear required an entirely different handle pivot in order to switch between right/left hand use. The newer gear and pivot can be used for either. To tell the difference between older gears, look at the long end of the gear shaft. On the older gear, the threads for the pivot go all the way up to the lip. On the newer gear, they are around 1/4" down in the shaft. The older pivot WILL NOT fit in the newer gear, nor will the older handle collar fit on the newer pivot (the thread diameters are incompatible). IF YOU HAVE AN OLDER GEAR, THIS HANDLE WILL NOT FIT.
Standard handle for the 950SSm
Optional after slight modification for 650SSm:
Handle collar is too short and must be shimmed up with QTY (2) 20A-720
See similar products below.
Related Products
is also our credit card processor
under our MysticParts account
for all purchases as of 1/19/2024
12/21/2023 Got it! Its perfect. Thank you so much. It was just on a whim that I even searched for this part. Hard to believe that I could get a reel part for a reel that is 30 plus years old. Thanks again,
1/16/2024 Comprehensive parts list, easy to order, and prompt service. I will definitely use them again.
1/4/2024 Quite a few years doing business with great folks. Simply the best. Thanks for your commitment to the business 👍
